ETS-Lindgren HI-3550 Magnetic Field Monitor (Archived) - Manual (Page 22)

HI n 3550 Manual Page — 17
Figure 8
Ready for Alarm ON/OFF Setting
5.5 Alarm Function
Selecting the Alarm Mode
1. Slide the Measurement Mode switch to STBY.
2. Press LOCK button for approximately three seconds
to shift to the alarm set mode. The alarm display
will be indicated on the LCD readout.
Activating/Deactivating the Alarm
When the alarm set mode is initiated, the word OVER
appears and the alarm symbol blinks (upper left corner of
the display).
The alarm is toggled on and off each time you press the
SET button. When the alarm symbol blinks, the alarm is
on; when it disappears, the alarm is off. When
deactivated, no alarm sounds even if an alarm value has
been programmed.
Setting the Instantaneous Alarm Value
1. After the alarm set mode is activated, press the
SELECT button. The alarm set symbol is visible, the
word OVER disappears and both the ) B AL-SET
indicator and the instantaneous measurement units
(mT) appear. In addition, the most significant digit
of the instantaneous measurement value is blinking.
Archived 4/2/10