ETS-Lindgren HI-3550 Magnetic Field Monitor (Archived) - Manual (Page 25)

Page — 20 HI n 3550 Manual
Figure 11
Leading Zeros Suppressed
Ready for Alarm ON/OFF Setting Again
zeros of the integrating measurement alarm value will
be suppressed.
Changing the Alarm Settings
1. In the alarm set mode, press the SELECT button to
move to the value or unit you wish to change.
2. Press the SET button to program the desired value or
unit.
Ending Alarm Set Mode
When you have completed setting the alarms, press the
LOCK button for approximately three seconds. The
instrument returns to the stand-by mode, and the alarm
set mode is terminated. Switching directly to the
instantaneous or integrating measurement mode will also
terminate the alarm set mode automatically.
Alarm Indicators by Measurement Mode
When alarm values are programmed for both integrating
and instantaneous measurement modes, and the alarm is
ON:
a. In the integrating measurement mode, the I B
AL-SET, ) B AL-SET, and alarm indicators are visible.
b. In the instantaneous measurement mode, only the
Archived 4/2/10