ETS-Lindgren HI-3550 Magnetic Field Monitor (Archived) - Manual (Page 23)

Page — 18 HI n 3550 Manual
Figure 9
Instantaneous Measurement Alarm Value
Flashing Ready to Set
The instrument is now ready to be set to the desired
alarm value for the instantaneous measurement
mode.
2. Each time the SET button is pressed, the value of the
selected digit increments by one (1). Press SET until
the selected digit indicates the desired value.
3. Each time you press the SELECT button, the digit to
be programmed advances to the right. Proceed in
this manner, setting each individual digit, to set the
exact alarm value desired.
NOTE
When you proceed to step 4, the ) B AL-SET
mark goes out and the leading zeros of the
instantaneous alarm value are suppressed. For
example, 0050.0 is displayed as 50.0.
4. After you have programmed all digits of the alarm
value, pressing the SELECT button will switch the
instrument into the integrated alarm units-of-measure
programming mode. The I B AL-SET indicator and
the digits to be programmed appear on the lower line
of the display, and the integrating unit of measure
Archived 4/2/10