General Hydroponics EuroGrower - Manual (Page 4)

ASSEMBLY
STEP 5
Place Filter onto Mag Drive #2 Pump
and attach Pump Line.
STEP 6
Place Mag Drive #2 Pump into the Panda
Reservoir through the Reservoir Access
Hole and feed Pump Line and Power
Cord through small hole located next to
the Reservoir Access Hole.
STEP 8
Connect two Drain Elbows to create
a Drain Fitting. Insert wide end of the
Drain Fitting onto the plastic extension
located on the bottom of the Bato
Buckets. The smaller end of the Drain
Fitting fits into the hole on the upper
edge of Bato Bucket.
STEP 9
Place the Bato Bucket on top
of the Reservoir Lid so the
Bucket Drain rests in one of
the Drain Rail Holes.
STEP 7
Place the Drip Feed Line on top of the
Reservoir Lid between the two Drain
Rails and connect to the Pump Line.
Cover the Reservoir Access Hole with the
Access Lid.