Karcepts KSM01 - Manual (Page 13)

3. MOUNTING THE SHIFTER (continued…)
6. Install the cable cover plate with 1/4" cap screws (3/8” long) and 1/4" lock
washers. The cable cover plate is not symmetrical as one of the slots is higher
than the other by 1/32”. The higher slot needs to cover the front-to-back
motion cable. After installed, you can apply some silicone sealant around each
cable where they protrude from the cover plate.
7. Slide the whole assembly underneath the vehicle and up into the cut-out. You
may have to try multiple angles to get everything to slide up in there nicely. (If
any troubles arise getting it to fit, take a look from inside of the car to see if
there might be some more trimming of the chassis tunnel necessary to avoid
shifter box interferences.) Hand tighten the shifter mount to the rear shifter
mount bracket with two 1/4" cap screws (1/2” long), 1/4" lock washers, and 1/4"
flat washers. Move to the inside of the car and use two 1/4" cap screws (3/4”
long), 1/4" lock washers, and 1/4" flat washers to mount the front of the shifter
mount into place. You may tighten these screws firmly at this time. Now go
back under the car and finish tightening the rear of the shifter mount to the rear
mount bracket. You will most likely need a 7/16” open-end wrench for this, as
space is limited.