Karcepts KSM01 - Manual (Page 4)

2. MODIFYING YOUR CHASSIS
1. Cut out the hatched areas of the provided template as shown below.
You can fold the template about the crosshairs of the holes to aid in cutting.
2. Place vehicle on jack stands and remove the seats, shift knob, center console,
exhaust, and stock shifter from the chassis.
If using a chassis that was originally automatic, follow steps 3 & 4;
otherwise, skip to step 5.
3. Note the crosshairs shown in the picture below. The outer layer of sheet metal
in this area has large holes
punched out of it. The center of
these holes is where you will need
to mark, center punch, and drill two
11/32” holes into the second layer
of sheet metal. Before drilling, line
up the narrower hole pattern from
the template onto the markings.
Adjust your markings if slightly off
from what the template shows, then
proceed to drill.