Karcepts KSM01 - Manual (Page 14)

4. RUNNING THE CABLES
When using an EG/DC2 crossmember, run the cables underneath of the
crossmember and into the engine bay. You should be able to utilize a tapped hole
in the bottom of the crossmember to mount one of the cable mounting brackets
supplied with the RSX cables. If unable to utilize a tapped hole, tie wrap or affix
cables properly such that they do not contact the header, exhaust, or anything
else which may cause damage to them.
When using an EK crossmember, run the cables above the crossmember and into
the engine bay. Tie wrap or affix cables properly such that they do not contact the
header, exhaust, or anything else which may cause damage to them. Once
cables are run properly, attach their ends to the transmission using the factory
Honda mounting hardware.