Modifying your chassis (continued…) – Karcepts KSM01 User Manual
Page 9
Advertising
2. MODIFYING YOUR CHASSIS (continued…)
11. Hand tighten the shifter mount to the rear mount bracket utilizing two of the 1/4"
cap screws (1/2” long), 1/4” lock washers, and 1/4” flat washers.
12. Use a jack or a friend to hold up the front of the mount snug to the chassis.
13. Check alignment of holes drilled. If necessary, mark and slot holes out until you
can fully see the tapped holes of the front brackets. These extra steps were
provided due to multiple variables that can contribute to poorly aligned holes.
Advertising