Karcepts KSM01 - Manual (Page 8)

2. MODIFYING YOUR CHASSIS (continued…)
9. Temporarily install the rear shifter mount bracket underneath the vehicle with
two M8 cap screws, M8 lock washers, and M8 flat washers (additionally use the
extra M8 flat washers and lock nuts with an automatic transmission chassis).
The back side of the rear shifter mount bracket should just touch (desired
position) or may be a small distance away from the edge of an extra layer of
chassis sheet metal on each side once the hardware is in place.
Back side of rear shifter mount bracket
Edge of extra layer of chassis sheet metal
10. Attach the left and right front mount brackets to the shifter mount with two of
the 1/4" cap screws (3/8" long) and 1/4” lock washers. Square up the brackets
by holding them with a pair of pliers while tightening. Make certain to observe
the pictures below to properly identify where each bracket goes, as they are not
identical.
Tapered side of left bracket
Wider (left) bracket on this side; taper on top