Kontron CP6003-RC IPMI User Manual
User guide, Cp6003-sa/ra/rc ipmi firmware
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Revision History
- Imprint
- Disclaimer
- Table of Contents
- List of Tables
- 1 Terminology and Acronym Definitions 9
- 2 Related Publications 11
- 3 Standard IPMI Commands 15
- 4 AdvancedTCA and AMC Commands 20
- 5 Get Device ID Command with OEM Extensions 21
- 6 Set Firmware Parameters 22
- 7 Set Control State 23
- 8 Get Control State 24
- 9 Sensor List 25
- 10 Gigabit Ethernet Link Sensor Assignment 27
- 11 Thresholds - Standard Temperature Range 28
- 12 Voltage Sensor Thresholds 28
- 13 OEM Event/Reading Types 29
- 14 IPMI and Hot Swap LEDs Function 45
- 1. Introduction
- 2. IPMI Setup
- 3. IPMI Controller Hardware
- 4. IPMI Firmware
- 5. Supported IPMI and ATCA Commands
- 6. OEM Commands and Command Extensions
- 7. Sensors Implemented on the CP6003-SA/RA/RC
- 8. IPMI Firmware Code
- 9. FRU Data
- 10. XMC Card Support
- 11. uEFI BIOS Failover Control - Automatic SPI Boot Flash Selection
- 12. Hot Swap and Shutdown
- 13. LAN Functions
- 14. OS Support / Tools
- 15. IPMI and Hot Swap LEDs