Casio XJ-450 - Manual (Page 44)

44
Getting Ready
2.
Press the [ENTER] key.
z This applies the selected language, closes the “Language” window, and displays the
projected image from the connected device.
z You can change the display language selection later, if you need to. For details, see
“Option Settings1
J Language” on page 105.
z For details about projection operations, see “Projecting onto a Screen” on page 46.
z When you turn off the projector, the lamp goes out and the projector goes into a cool
down state. Note that you will not be able to turn the projector back on again while it is
cooling down.
z The projector may remain quite hot for a while after you turn it off. Avoid touching the
projector after you turn it off.
z Note that the projector may still be quite warm even after it completes its cool down
procedure. Before packing up the projector, it is recommended that you check to make
sure that the fan is stopped and that the projector is no longer warm.
To turn off the projector
1.
Press the [ ] (power) key.
z This causes a confirmation message like the one shown below to appear in the center
of the projection screen.
z If you do not turn off the projector the confirmation message will disappear
automatically after about 10 seconds. The confirmation message will also disappear if
you press [ESC] key.
Turning Off the Projector