La-Z-Boy La-Z-Touch Cooler Recliner with Massage & Heat 11/27/2011 - Manual (Page 4)

7 6
NOTICE:
Do not plug the transformer in until instructed.
1. Install the back.
• Lay the back across the chair arms. Lift the back at a slight angle and align
the brackets on the back with the brackets on the body (F
IGURE 1).
• Lower the back onto the body, making sure the back and body brackets are
completely engaged.
- To make sure the back is properly installed, with both sets of back and body brackets
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position, the brackets are not engaged (F
IGURE 2). Remove the back and
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy ® dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F IGURE 3).
2. The thermo-electric cooler power transformer, 2-motor massage and heat power transformer
and rubber mat are stored inside the cooler during shipping. Remove the power transformers
from the cooler and unwind the cords.
– To reduce the risk of product damage:
• Before operating, remove the white packing material located under
the cooler, inside the arm cavity.
3. Packing material is used under the thermo-electric cooler to protect and support the cooler
during shipping. The packing material must be removed before operating the cooler to prevent
damage. Lift the thermo-electric cooler from the chair arm and set in the seat (F
IGURE 4).
Remove the white packing material from inside the arm cavity (F IGURE 5).
4. Carefully lower the thermo-electric cooler into the chair arm, making sure the power connector
is toward the back of the chair (F IGURE 6).
5. To access the massage connectors, stand at the side of the chair and push the back
rearward to recline the seat and back. Hold the top arm closed to prevent the cooler from
falling out, and gently tip the chair forward to rest on its arms and the top of the back.
NOTICE:
F IGURE 2
F IGURE 4 F IGURE 3
F IGURE 1
F IGURE 6 F IGURE 5
White Packing
Material Thermo-Electric Cooler
Power Connector
Body
Bracket
Back Bracket
Back and body brackets on this side
are not engaged. Remove the back
and reinstall.
Back
Bracket
Locking
Lever
Locked
Position
Chair
Back
Thermo-Electric Cooler Recliner with 2-Motor
Massage & Heat Assembly Instructions
Thermo-Electric Cooler Recliner with 2-Motor
Massage & Heat Assembly Instructions
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
WARNING
(Assembly Instructions Continued)