La-Z-Boy La-Z-Touch Cooler Recliner with Massage & Heat 11/27/2011 - Manual (Page 9)

17 16
- To reduce the risk of injury:
• This unit is equipped with a tension adjustment feature for the reclining mechanism
that is preset at the factory. The tension setting can be changed for your personal
preference. To avoid tipover and assure stability, do not operate the unit with the
tension adjustment wing nuts completely loosened.
- To reduce risk of product damage:
• Make sure the legrest is closed before tilting forward and adjusting the tension.
• Do not completely tighten the wing nuts. The tension springs should not be completely
compressed after making adjustments. If this occurs, the wing nuts must be loosened
a minimum of
1 ⁄2-turn to avoid damage to the spring tension assembly.
• Do not completely loosen the wing nuts. The spring should not slide on the bolt
after making adjustments. If the spring slides on the bolt, tighten the wing nut
clockwise a minimum of
1 ⁄2-turn, after the spring no longer slides on the bolt.
• Adjust both wing nuts equally.
Reclining Tension Adjustment Instructions
You can adjust the tension of the reclining mechanism to respond to your individual size.
1. Unplug both power transformers from the electrical outlet. Gently roll the reclining chair
forward to rest on its arms and top of the back. Locate the wing nuts, one on each side,
toward the back of the recliner under the reclining seat (only one side shown below).
2. Adjust the tension by turning the wing nuts in ¼-turn increments until the
desired setting is reached.
• A taller or heavier person may choose to increase the reclining tension by tightening
the wing nuts clockwise.
• A smaller person may choose to decrease the reclining tension by loosening the wing
nuts counterclockwise.
3. Return the reclining chair to the upright position and test the new setting. Make additional
adjustments if needed, repeating these steps. Plug both power transformers directly into
a wall outlet.
Reclining Tension Adjustment Instructions:
Tension Spring Wing Nut
WARNING
NOTICE:
To Operate the Legrest
1. Your reclining chair is equipped with a three-position locking legrest for seating comfort.
Simply rotate the handle to operate the legrest (F IGURE 1). You may stop in any one of three
ideal positions. The 1st position is slightly inclined for relaxed reading (F IGURE 2). The 2nd
position is slightly more inclined for comfortable television viewing (F IGURE 3). The 3rd
position is fully extended for complete relaxation (F IGURE 4). To lower the legrest, rotate
the handle counterclockwise to the fully extended position, then rotate clockwise to the
fully closed position.
2. The chair back can be reclined with the legrest closed or extended. To recline,
apply pressure to the back. Sit upright to return the back to an upright position.
3. Bring the back upright and close the legrest before getting out of the chair.
Additional Feature on Selected Styles
The chair body can be tilted back when the legrest is in use. Shifting your body weight
rearward will cause the chair body to tilt backward offering a number of different positions.
3-Position Legrest Operating Instructions:
F IGURE 1
F IGURE 3
F IGURE 2
F IGURE 4
CLOSED
POSITION 1ST POSITION
2ND POSITION 3RD POSITION
- To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area
rugs at a distance to allow the legrest to fully extend without rubbing or interference.
• To safely exit the unit and prevent a tripping hazard, bring the back
upright and close the legrest.
- To reduce risk of product damage:
• Damage will occur to the mechanism if the legrest is forced closed from the 1st
or 2nd position. The legrest must be extended to the 3rd position and then closed.
WARNING
NOTICE: