La-Z-Boy Shiatsu Massage - Manual (Page 6)

11 10
Shiatsu Massage Recliner
Assembly Instructions:
Shiatsu Massage Recliner
Operating Instructions:
– To reduce the risk of serious injury:
• Check the condition of the power transformer, electrical cords, plug and connectors
monthly. Keep the power transformer and electrical cords away from heat sources.
Never operate the unit with a damaged power transformer, electrical cord, plug or
connector. Contact your La-Z-Boy
® dealer for service.
WARNING
7. Connect the power cord to the power transformer (F IGURE 6, below). Do not plug in until
instructed in the operating instructions.
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
WARNING
8. Choose a location that is close to an electrical outlet. Proceed to the Operating Instructions.
NOTICE: To prevent damage to the connectors and cords, it is important
to unfasten all connections prior to removing the back.
9. To remove the back, unplug the power cord from the electrical outlet and disconnect
the power transformer from the connector behind the chair. Reverse the Assembly
Instructions steps.
F IGURE 6
Power
Transformer Power Cord
– To reduce the risk of serious injury:
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
DANGER
– To reduce the risk of serious injury:
• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the back
of the unit. Move the unit into or out of the reclining position slowly, making sure that
no children or pets are in close proximity.
• The 1SM and 1SN Shiatsu massage chairs are intended for a single occupant not
exceeding 300 pounds. Do not operate the chair with more than one occupant in
or on any part of it.
• To safely exit the unit and prevent a tripping hazard, bring the back upright
and close the legrest.
WARNING
Plug the power cord directly into a wall outlet. Make sure there is enough slack in the cord running
from the chair to the outlet to allow for rocking and reclining. Never stretch or strain a cord.
The Shiatsu massage chair has a double-upholstered back designed to provide two levels of massage.
Leave the front back pillow in place for a gentle, relaxing massage (F
IGURE 1). Or flip the front back
pillow over the top of the chair for a vigorous massage (F IGURE 2). Either method of massage can be
intensified by massaging in the reclined position.
Leave the front back pillow in place when using the massage for the first time. Sit in the center of
the seat for the proper massage position. Lean straight back, without twisting your body, so the
massage rollers are in position on either side of your spine. Press the Power button and then select
the Full Back, Lower Back or Upper Back button to begin the Shiatsu massage. Refer to the Hand
Wand diagram on the following page.
The massage will shut off after 15 minutes but may be restarted for another 15 minute session.
DO NOT use the massager for more than 30 minutes at a time.
F IGURE 1 F IGURE 2
Front Back Pillow Front Back Pillow
Make this
connection