Losi LOSB9606 User Manual

Page 16

Advertising

WARNING AND SAFETY NOTES

INC

LiFe
V.Type 3.3V

W a s t e t i m e
C H G / D C H G 5 m i n

C a p a c i t y C u t o f f
ON

5 0 0 0 m A h

S a f e t y t i m e r
O N 1 2 0 m i n

- +

LiFe
V.Type 3.3V

K e y B e e p O N
B u z z e r O N

V.Type 3.3V

- +

There is a 3-pin port on the left side of the charger used as a USB interface or temperature sensor port. When
configured to display temperature, you can display the surface temperature of your battery using the optional
temperature probe . You can set the maximum allowable temperature of the battery while charging. The
process will be terminated automatically to protect the battery once it reaches this temperature. This feature
requires the temperature probe (optional). If the port is configured as a USB port, you can connect and monitor
the charger with your PC using the optional USB cable and software.

The battery will heat up after cycles of charge and discharge. The program will
insert a time delay after each charge/discharge process to allow the battery
sufficient time to cool down before starting the next cycle. The valid value
ranges are from 0 to 60 minutes.

When charging begins, the integrated safety timer starts. If an error is detected
or the termination circuit cannot detect whether the battery is fully charged or
not, the safety timer will help to prevent overcharging. Please see the following
page to calculate the appropriate safety timer duration.

The capacity cutoff feature protects against overcharging the battery when
delta-peak voltage cannot be detected or the safety timer times out. When the
battery reaches the maximum capacity that you have set, charging will be
automatically terminated.

The charger beeps each time you press a button to provide feedback of your
action. The charger also beeps or plays melody sounds during operation to
confirm different mode changes. These functions can be turned on or off.

This function monitors the voltage of the input battery used to power the
charger. If the voltage is lower than the value you set, the program will be
automatically terminated to protect the input battery.

I n p u t p o w e r l o w
C u t o f f 1 0 . 0 V

Advertising