Losi LOSB9606 - Manual (Page 4)

Maximum safety
SPECIAL FEATURES
Automatic charging current limit
Capacity limit
Temperature threshold*
Processing time limit
Input power monitoring
Data store/load
03
Delta-peak sensitivity: The automatic charge termination is based on the principle of delta-peak voltage
detection. When the battery’s voltage exceeds the threshold, the process will be terminated automatically.
You can set the upper limit of the charging current when charging NiCd and NiMH batteries. This is useful for
NiMH batteries of low impedance and capacity when using the ‘AUTO’ charging mode.
The charging capacity is calculated as the charging current multiplied by time. If the charging capacity exceeds
the limit, the process will be terminated automatically when it reaches the maximum value you have set.
To protect your car’s battery from being over discharged when used as the DC power input, the voltage is
continuously monitored. If the voltage drops below the lower limit, the process will be ended automatically.
Data for a maximum of five batteries can be stored for your convenience. You can store data pertaining to
program settings of the battery for continuous charging or discharging. Users can recall this data at any time
without any special program setting.
The battery’s internal chemical reaction will cause the temperatue of the battery to rise. If the temperature limit
is reached, the process will be terminated automatically.*
* This function is available by connecting the optional temperature probe, not included.
You can also limit the maximum process time to avoid overcharging your battery.