Br eak down ass ist ance, Towing and tow-starting – Mercedes-Benz G-Class 2014 Owners Manual User Manual

Page 309

Advertising
background image

Rear towing eye : is located under the

bumper, on the left-hand side when viewed in

the direction of travel.

Towing a vehicle with both axles on

the ground

It is important that you observe the safety

instructions when towing away your vehicle

(

Y

page 305).

X

Switch on the hazard warning lamps

(

Y

page 104).

i

In order to signal a change of direction

when towing the vehicle with the hazard

warning lamps switched on, use the

combination switch as usual. In this case,

only the turn signals for the desired

direction flash. When you reset the

combination switch, the hazard warning

lamps start flashing again.

X

Turn the SmartKey to position 2 in the

ignition lock (

Y

page 139).

X

When the vehicle is stationary, depress the

brake pedal and keep it depressed.

X

Shift the transfer case to

neutral(

Y

page 195).

X

Shift the automatic transmission to

position N.

X

Release the brake pedal.

X

Release the parking brake (

Y

page 157).

i

The transmission can only change gear if

the battery has sufficient charge.
If you cannot move the selector lever to N,

the propeller shafts to the driven axles

must be removed.

Transporting the vehicle

!

You may only secure the vehicle by the

wheels, not by parts of the vehicle such as

axle or steering components. Otherwise,

the vehicle could be damaged.

Use the towing eyes to pull the vehicle if it

needs to be transported on a trailer or

transporter (

Y

page 306).

X

Apply the parking brake.

X

Turn the SmartKey to position 2 in the

ignition lock (

Y

page 139).

X

Move the selector lever to N.

X

Shift the transfer case to neutral

(

Y

page 195).

X

Secure the towing cable to the towing eyes

(

Y

page 306).

X

Make sure that the vehicle cannot roll

away.

X

Release the parking brake.

X

Load the vehicle onto the transporter.

As soon as the vehicle has been loaded:

X

Apply the parking brake.

X

Shift the automatic transmission to

position P.

X

Turn the SmartKey to position 0 in the

ignition lock (

Y

page 139) and remove it.

X

Secure the vehicle.

Recovering a vehicle that has become

stuck

!

When recovering a vehicle that has

become stuck, pull it as smoothly and

evenly as possible. Excessive tractive

power could damage the vehicles.

If the drive wheels have become stuck in

loose or muddy ground, pull the vehicle out

with extreme caution, especially so if the

vehicle is loaded.
Never attempt to recover a stuck vehicle with

a trailer attached.
Pull out the vehicle backwards, if possible

using the tracks it made when it became

stuck.

Towing and tow-starting

307

Br

eak

down

ass

ist

ance

Z

Advertising