Mercedes-Benz GLK-Class 2010 Owners Manual - Manual (Page 310)

Corner-illuminating lamps bulb (Bi-
Xenon headlamps only)
X Turn housing cover : counterclockwise
and remove it.
X Press handle ; in direction of the arrow
until the bulb socket is released.
X Pull out the bulb socket using handle ;.
X Gently press the new bulb into bulb socket.
Lamp pin = must point up.
X Insert bulb socket.
X Pull bulb socket handle ; until the bulb
socket engages.
X Align housing cover : and turn it
clockwise.
X Driver’s side only: Fix the washer fluid
reservoir (
Y page 306).
X Install the cover above the headlamp
(
Y page 306).
Turn signal and side marker lamps
X Turn bulb socket : or ;
counterclockwise and pull it out together
with the bulb.
X Turn signal lamp bulb PY 21 W: Press the
bulb in slightly and turn it
counterclockwise. Pull it out of bulb
socket ;.
X Insert new bulb into bulb socket ;. Press
the bulb in slightly and turn it clockwise.
X Turn signal and side marker lamp bulb
WY 5 W: Pull the bulb out of bulb
socket :.
X Insert the new bulb into bulb socket :.
X Insert bulb socket ; or :.
X Turn bulb socket ; or : clockwise until
it engages.
X Driver’s side only: Fix the washer fluid
reservoir (
Y page 306).
X Install the cover above the headlamp
(
Y page 306).
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X Switch off the ignition.
X Turn the exterior lamp switch to position
$.
X Open the tailgate.
308
Replacing bulbs
Practical hints
X204_AKB; 3; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T19:16:58+02:00 - Seite 308