Rear window wiper/washer, Problems with wipers, Controls in detail – Mercedes-Benz E-Class 2009 Owners Manual User Manual

Page 121

Advertising
background image

Wipers

119

R

the automatic transmission is in drive
position

D or reverse gear R

or

R

the wiper setting is changed using the
combination switch

Single wipe

X

Press the combination switch briefly in
direction of arrow

2

to the resistance

point.
The windshield wipers wipe one time
without washer fluid.

Wiping with washer fluid

X

Press the combination switch in direction
of arrow

2

past the resistance point.

The windshield wipers operate with washer
fluid.

i

To prevent smears on the windshield or

noisy/chattering wiper blades, wipe with
washer fluid every now and then even when
it is raining.

For information on filling up the washer
reservoir, see “Washer system and headlamp
cleaning system” (

Y

page 246).

For information on cleaning the headlamps
with washer fluid, see “Headlamp cleaning
system” (

Y

page 114).

Rear window wiper/washer

Combination switch
1

Rear window wiper switch

%

Wiping rear window with washer fluid

&

Intermittent wiping

(

Rear window wiper off

)

Wiping rear window with washer fluid

X

Switch on the ignition.

The rear window wiper engages automatically
when the automatic transmission is shifted
into reverse gear

R with the windshield wipers

switched on.

X

Activating intermittent wiping: Turn rear

window wiper switch

1

to position

&

.

X

Deactivating intermittent wiping: Turn

rear window wiper switch

1

to position

(

.

X

Wiping with washer fluid: Turn and hold

rear window wiper switch

1

in position

%

or

)

until the rear window is clean.

For information on filling up the washer
reservoir, see “Washer system and headlamp
cleaning system” (

Y

page 246).

Problems with wipers

!

If anything blocks the windshield wipers

(leaves, snow, etc.), switch them off
immediately.
For safety reasons, stop the vehicle in a
safe location, and

R

-

remove the SmartKey from the starter
switch
or

-

turn off the engine by pressing the
KEYLESS-GO start/stop button and
open the driver’s door (with the
driver’s door open, starter switch is in

Controls in detail

Z

Advertising