Mercedes-Benz G-Class 2008 Owners Manual - Manual (Page 214)

213
Controls in detail
Loading
Hanging up partition net
1 Partition net
2 Holder
̈ Hang partition net 1 on holder 2 and
push forward in direction of the arrow.
Pulling partition net tight
3 Lift tensioner
4 Tightening belt
5 Belt hook
6 Cargo tie-down ring
Lift tensioner 3 on tightening belt 4
must point in direction of the tailgate.
̈ Use lift tensioner 3 to set the length
of tightening belt 4 to cargo tie-down
ring 6.
̈ Hook belt hook 5 into cargo tie-down
ring 6.
̈ Pull tightening belt 4 by the loose end
until the partition net is pulled tight.
̈ After driving a short distance, make
sure the partition net is still tight and, if
necessary, pull it tight again.
Loosening partition net
̈ Loosen tightening belt 4 by pulling lift
tensioner 3 upward.
̈ Remove belt hook 5 from cargo
tie-down ring 6.
Removing and storing partition net
̈ Take partition net 1 out of holder 2.
̈ Roll up partition net and secure it.
̈ Store partition net behind the rear seat
bench.
W463.boo Seite 213 Montag, 19. November 2007 8:41 08