Modern AG 15' Predator - Omni - Manual (Page 2)

introduction
Your heavy-duty cutter is designed primarily for weed, grass and brush to 3 1/2” diameter.
With proper maintenance as described in the manual, your cutter will provide you with years of
dependable service with a minimum of repairs.
It is recommended that all operators of this implement read this manual or be instructed of its
contents as to safety, proper operation, and maintenance before beginning operation.
Your cutter has been assembled for operation with a tractor PtO input speed of 540 or 1000 RPm.
Verify your RpM with your local dealer prior to operation. Should you desire to change pTO input
speed, contact your local dealer. this series of cutter is recommended for use with tractors rated
at 50 HP (37 KW) to 120 HP (75 KW) for 540 RPm drive and 50 HP (37KW) to 140 HP (104KW) for
1000 RpM drive.
When ordering parts for the gear boxes and the drivelines, be sure to specify the serial number.
the serial number is located on the front right panel on the center deck.
Chain guards, deflectors, driveline integral shields are standard equipment and need to be used at
all times.