Modern AG 15' Predator - Omni - Manual (Page 38)

38 - 15’ Predatorrr
operation section
the operator’s manual and decals affixed on the unit contain important instructions on the safe
and proper use of the equipment. maintain these important safety features on the implement in
good condition to ensure the information is available to the operator at all times.
• ensure the manual canister is secured to the equipment with the operator’s manual inside.
• ensure all decals are in place and legible. Replace missing, damaged, and illegible decals.
• ensure the cutter hitch is securely attached to the tractor drawbar with a proper size bolt
and secured nut.
• ensure that a properly rated safety tow chain is equipped securing the cutter to the tractor.
• Check that the main driveline is securely attached to the tractor and the clamping cone is
seated in the groove of the pTO shaft.
• ensure the divider drivelines are secure at both ends.
• ensure chain guards and/or rubber deflectors are in position and not damaged. Replace
worn, broken, and missing sections immediately.
• ensure the driveline integral shields are in good condition and rotate freely.
• Inspect that all bolts and screws are in position and are properly torqued.
• ensure the tractor PtO master shield is in place, lowered and in good condition.
• ensure each cutter slip clutch shield is secured in place and in good condition.
• ensure the driveline slip clutches are properly adjusted and the friction plates are not frozen
together. Reference the Maintenance Section for proper slip clutch maintenance.
• Perform scheduled lubrication as specified in the maintenance section.
• Inspect each gearbox oil level and replenish if needed. a low oil level is a warning sign that the
gearbox may be cracked or its seal is damaged and needs to be replaced.
• ensure all gearbox vents are in place and free from clogs.
• Inspect blades and blade bolts for looseness and excessive wear. make sure the cutter is
securely blocked up before crawling beneath. Replace damaged, worn, and missing blades
as complete sets to maintain rotary balance.
• ensure carrier hub nuts are tightened with the cotter pin inserted and spread.
• Inspect the condition of the deck skid shoes and the skid shoe attaching hardware.