Drivelines, Figure 5 figure 6 – Modern AG 15' Predator - Omni User Manual
Page 64
64 - 15’ Predatorrr
Maintenance section
Recommended lubricant is exxon - Spartan eP220, mobil HD 80W90, or equal. Required lubricant is
a Sae 90 or Sae 80W90 with eP additives for extreme pressure and temperature, with an aPI-G1-5
Service rating.
drivelines
the drivelines and u-Joints should be inspected each morning before the cutter is started.
FIGuRe 5 & 6
the u-Joint and CV Joint on the driveline undergo extreme forces when the unit is turning or when
the wings are being raised. It is important that the u-Joints and CV Joints be greased each day
before the unit is started. the u-Joint and CV Joint assemblies are located at each end of the Center
and wing drivelines. the CV joint is located at the end of the main driveline. the u-Joint and the CV
joint are accessible by rotating the driveline safety shield until the hole in the shield matches up with
the grease fitting. use #2 bearing grease for lubrication. Inspect the u-Joint. If there is noticeable
movement in the driveline, replace the u-Joint before it causes severe damage to the driveline.
figure 5
figure 6
GReaSe eVeRY
8 HOuRS
GReaSe eVeRY
8 HOuRS