General-info, General information – Oldcastle BuildingEnvelope FG-2000 User Manual
Page 3
GENERAL INFORMATION
PRODUCT USE
The FG-1000 and FG-2000 flush glazing systems by Oldcastle BuildingEnvelope™ are intended for installation
by glazing professionals with appropriate experience. Subcontractors without experience should employ a
qualified person to provide field instruction and project management.
Oldcastle BuildingEnvelope™ does not control the application or selection of its product configurations, sealant
or glazing material and assumes no responsibility thereof. It is the responsibility of the owner, architect and
installer to make these selections in strict compliance with applicable laws and building codes.
Consult sealant manufacturer for review and recommendation of sealant application. Follow sealant
manufacturer’s recommendations and literature for proper installation.
The air and water performance of the FG-1000 and FG-2000 flush glazing systems are directly related to the
completeness and integrity of the installation process of both the seal installed at the horizontal to vertical
connections and the glazing gaskets. To insure top performance for this system, particular attention should be
given the following procedures:
1. Surfaces to be sealed with tacky tape should be cleaned with isopropyl alcohol or solvent and dried as
recommended by sealant manufacturer to remove all dirt and cutting oils.
2. The glazing gaskets should be installed so as to avoid stretching, buckles or tears. Corners must be cut
square, sealed and butted together. To avoid damage to gasket and corner joints during glazing, glass
should be level and straight during installation.
Variations on the details shown are inevitable and are not the responsibility of Oldcastle BuildingEnvelope™
when drawn by others. Oldcastle BuildingEnvelope™ strongly encourages i
ts customers to use its engineering
department for calculations and shop drawings.
Consult glass manufacturer for correct setting block location and length for glass sizes in excess of 40 sq.ft.
PROTECTION AND STORAGE
Handle all material carefully. Do not drop from the truck. Stack with adequate separation so the material will
not rub together. Store material off the ground, protecting against the elements and other construction hazards
by using a well ventilated covering. Remove material from package if wet or located in a damp area. For further
guidelines consult AAMA publication CW-10, “Care and Handling of Architectural Aluminum From Shop to
Site.”
CHECK MATERIAL
Check glass dimensions for overall size as well as thickness. Oldcastle BuildingEnvelope™ cannot be held
responsible for gaskets that are not water tight due to extreme glass tolerances. The FG-1000 and FG-2000
flush glazing systems are designed to accommodate glass or panels measuring ¼” in thickness. (+/- 1/32”).
Check all material upon arrival at job site for quality and to determine any shipping damage.
Using the contract documents, completely check the surrounding conditions that will receive your materials.
Notify the general contractor by letter of any discrepancies before proceeding with the work. Failure to do so
constitutes acceptance of work by other trades.
Check shop drawings, installation instructions, architectural drawings and shipping lists to become familiar with
the project. The shop drawings take precedence and include specific details for the project. The installation
instructions are of a general nature and cover the most common conditions. Due to varying job conditions all
sealant used must be approved by the sealant manufacturer to insure it will perform per the conditions shown on
the instructions and shop drawings. The sealant must be compatible with all surfaces in which adhesion is
required, including other sealant surfaces. Use primers where directed by sealant manufacturer. Properly store
sealant at the recommended temperatures and check sealant for remainder of shelf life before using.
2
FEBRUARY 2012
F L U S H G L A Z E S E R I E S 1 0 0 0 a n d 2 0 0 0 I N S T A L L A T I O N M A N U A L