2 remote id, 1 students – QOMO QRF300 User Manual User Manual
Page 81
Copyright © 2009 All Rights Reserved by QOMO HiteVision.
www.qomo.com
81
The System settings contain audio settings and the instructor remote control mouse sensitivity
settings (This function is not available in this system).
The audio setup allows the selection of sounds to be used when entering a quiz, starting a quiz, and
completing a quiz.
To set up the audio sounds, follow these steps:
1.
Select
Settings
Tab.
2.
Click the
System
icon; this will display the
System Settings
window.
3.
Click on the sound activity check boxes you desire and the
Browse
… button will be
displayed. Click the
Browse
button; this will display the sound file browser. Select the
desired sound file for the activity and then click the
Save
button to save it into the system.
4.
Repeat step 3, if you desire to set up additional sounds for other activities.
Note:
If the check box is unchecked, the sound will be muted for that activity.
3.5.2 Remote ID:
The function is
used to set up the student remote keypad device ID. All settings require the user to
log in the system to perform.
3.5.2.1 Students
Student ID
There are two ways to set up the student device ID.
1.
Click the
Set
button to set up the student device ID.
To set the student device ID, follow these steps:
1) From the main QClick window, select
Settings
tab, then click
Remote ID
to display the
Set Remote ID
window. The default shows the
Students tab
.
2) Enter the remote ID number into the text box under
Chang To
: on the right by directly
typing or clicking the digital up or down buttons next to the box.
3) Press and hold the key ‘
B
’ and then press the key ‘
Rush Quiz
’ on the student keypad.
4) After the red indication light start flashing, release both keys at the same time.