3 channel set – QOMO QRF300 User Manual User Manual
Page 84
Copyright © 2009 All Rights Reserved by QOMO HiteVision.
www.qomo.com
84
Note
:
Once the new ID has been set successfully, the color of the Set button changes to green. If
the set up is failure, the color changes to red.
3.5.2.3 Channel Set
To set the host main receiver channel number and the band number, follow these steps:
1.
From the main QClick window, select
Settings
tab, then click
Remote ID
to display the
Set
Remote ID
window.
2.
Select the
Channel Set
tab.
3.
The software will prompt you to login again to double check if you have the authority to
change the main receiver channel.
4.
After login, the
Set Remote ID
window displays. Enter the new channel number into the text
box next to the
Channel No.
. Then click the
Send
button
.
5.
If you want to set a new band for the setting channel. Enter the new band number into the
text box next to the
Band
. Then click the send button
6.
Click the
Close
button
to close the setting.
Note:
The valid channel number is from 0 to 49 and the valid band number is from 0 to 3.