QOMO QRF300 User Manual - Manual (Page 82)

Copyright © 2009 All Rights Reserved by QOMO HiteVision.
www.qomo.com 82
5) Click the Set button to set the new ID you have entered.
Note: Once the new ID has been set successfully, the color of the Set button changes to green. If
the set up is failure, the color changes to red.
2. You can also click the Test button to set up the student remote ID.
To set up the student device ID, follow these steps:
1) Click the Test button to display the Set remote ID and the Hardware test tab.
2) Press and hold the key ‘ B ’ and then press the key ‘ Rush Quiz ’ on the student keypad.
3) After the red indication light start flashing, release both keys at the same time.
4) Click a row number on the table to set the device ID to the corresponding row number.
(You can turn the pages by clicking the button or )
Note: Once the new ID has been set successfully, the color of the row you click changes to green. If
the set up is failure, the color changes to red.
Test
You can click the Test button in the students tab or click the Hardware under Settings
window to test the student remote keypad stroke.
To use the hardware test tool, follow these steps:
1. Click the Hardware button to display the Hardware test window.