QOMO QRF300 User Manual - Manual (Page 83)

Copyright © 2009 All Rights Reserved by QOMO HiteVision.
www.qomo.com 83
2. Press a key on the student keypad; the key result will display on the corresponding ID row.
(This test can only test one student keypad for a time.)
3. Press a key on the instructor keypad; the result will display on the teacher’s key grid.
You may press the Reset button to clear the test results; turn the pages by clicking the
button or and press the OK button to close the test window.
3.5.2.2 Teacher
To reset the instructor remote keypad, follow these steps:
1. From the main QClick window, select Settings tab, then click Remote ID to display the Set
Remote ID window.
2. Select the Teacher tab.
3. Press and hold the key ‘ Start ’ and then press the key ‘ OK ’ on the instructor keypad.
4. After the red indication light is flashing, release both keys at the same time.
5. Click the Set button to set the new ID.
Note : Setting the new ID means that the instructor keypad would match the currently plugged in
main receiver channel.