SINGER 9960 QUANTUM STYLIST - Manual (Page 20)

20
FUNCTION OF EACH PART
A. START/STOP BUTTON
The machine will start running when start/stop
button is pressed and will stop when pressed the
second time. The machine will rotate slowly at
start of sewing.
MONITOR LAMP
Green Light “ON”
Ready to sew or bobbin winding.
Red Light “ON”
Presser foot is not in down position or buttonhole
lever is not lowered.
If the red light is on, the machine will not start even
when start/stop button is pressed.
If upper thread is not threaded, machine will stop
after a few turns. (Upper thread sensor)
Note:
When the foot controller is connected, start/stop
button will be deactivated.
B. REVERSE STITCH BUTTON
The machine will continue to sew in reverse at low
speed while this button is pressed and stop when
this button is released.
Note:
When the foot controller is connected, machine
will sew in reverse while this button is pressed.
When released, machine will sew forward.
C. NEEDLE UP-DOWN / SLOW BUTTON
Pressing this button when the machine is stopped,
will change the needle position from down to up or
from up to down.
While sewing, by pressing this button, machine
will sew in slow speed. Pressing this button again,
the speed will return.
D. SPEED CONTROL BUTTON
The machine will sew faster when the button is slid
to the right, and sew slower when the button is slid
to the left.
Note:
When the foot controller is connected, this button
limits the maximum speed.
E. PRESSER FOOT LIFTER
The presser foot is lifed up or down by this lever.
Note: Machine will not start when the presser foot
is lifted. (Except for bobbin winding)