Threading the upper thread – SINGER 1507WC User Manual

Page 31

Advertising
background image

This is a simple operation but it is important to carry out

correctly as by not doing so

.

-Start by raising the needle to its highest point (1), and also

raise the presser foot to release the tension discs. (2)

For safety, it is strongly suggested you turn off the

power before threading.

-Lift up the spool pin. Place the spool of thread on the

holder with the thread coming off the spool as shown. For

small thread spools, place small side of spool holder next

to spool.(3)

-Draw thread from spool through the upper thread guide. (4)
-Guide thread around thread guide (5) pulling thread

through pre-tension spring as illustrated.

-Thread tension module by leading thread down right channel

and up left channel (6). During this process it is helpful to

hold the thread between the spool and thread guide (4).

-At the top of this movement pass thread from right to left

through the slotted eye of the take-up lever and then

downwards again. (7)

-

(9)

If your sewing machine is equipped with the factory

installed optional automatic needle threader, instructions

for use can be found on page 26.

several sewing problems could

result

Note:

Note:

Now pass thread behind the thin wire needle clamp guide

(8) and then down to the needle which should be threaded

from front to back. Pull about 6-8 inches of thread to the

rear beyond the needle eye. Trim thread to length with built

in thread cutter.

24

Threading the upper thread

GB

3

4

2

5

6

7

8

1

3

4

7

2

5

6

8

Advertising
This manual is related to the following products: