SINGER S10 STUDIO Instruction Manual - Manual (Page 28)

28
w r
e
Step z
Raise the presser foot. Check that the machine has
not run out of bobbin thread. Rewind bobbin if
needed and replace in bobbin case.
Check that the thread is feeding evenly off of the
thread spool and re-thread the needle.
If the carriage position makes threading the needle
difficult, you can move the hoop for easier
threading by pressing the home position button q.
After rethreading the needle thread, press the
home position button q again to return the carriage
to the previous position.
q Home position button
Step x
Press the stitch back button w or stitch forward button
r to move the embroidery hoop to where the thread
broke or quit stitching e. Press the stitch back
once w to move the hoop back by 10 stitches.
w Stitch back button
e Point of thread breakage
r Stitch forward button
When embroidering a design, thread breakage can
occur. Also, the bobbin may run out of thread before the
design is finished.
Follow these steps to re-thread the machine and return
the needle to the position where stitching should resume.
q
Needle or Bobbin Thread Breaks
Step v
Lower the presser foot. Press the start/stop button
and sew 5 to 6 stitches.
Step b
Press the start/stop button again to stop the
machine. Raise the presser foot. Trim the thread tail
at the beginning of the stitching.
Step n
Lower the presser foot and press the start/stop
button. The machine will sew the first color section
and stop automatically when it has finished.
Step m
Select OK √ and change the thread to its next color.
Sew the next section.
Step ,
Continue sewing and changing threads until the
design is finished. The machine will buzz when
design is complete. Select the OK √ button to return
to the beginning of design.
Step .
Select the exit X button to return to the design
selection screen.
vbn
m,.
zx