SINGER S10 STUDIO Instruction Manual - Manual (Page 9)

9
Step v
Press the start/stop button again and continue filling
the bobbin. When the bobbin is fully wound it will stop
filling the bobbin.
Press the start/stop button to stop the machine motor.
return the bobbin winder spindle to the left.
remove the bobbin and cut the thread with the bobbin
thread cutter.
e Bobbin thread cutter
NOTE
do not move the bobbin winder spindle while the
machine is running. For safety purposes, the motor will
stop automatically after running for two minutes after
bobbin has been filled.
q
w
e
z
x
c
v
Winding the Bobbin
Step z
guide the thread around the bobbin winder thread
guide while holding the thread with both hands.
q Bobbin winder thread guide
Step x
thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the bobbin
winder spindle.
w Bobbin winder spindle
Step c
Push the spindle to the right. Press the start/stop
button while holding the end of the thread. Stop
the machine after the bobbin is wound a few layers.
Cut the thread close to the hole on top of the bobbin.
CAUTION
use only Singer ® Class 15 bobbins in your
machine. using improperly sized bobbins
or pre-wound bobbins may cause stitching
problems. improper bobbins can damage
your bobbin case and machine.
NOTE
For best results, use bobbinfill thread in the bobbin for
embroidery. Bobbinfill thread is lighter in weight than
all-purpose thread, making the design less dense on
the back side of the fabric.