Tjernlund DCOP1 Constant Operating Pressure Draft Control 8504174 (Discontinued) - Manual (Page 14)

13
UC1 UNIVERSAL CONTROL CONNECTED WITH A HONEYWELL R8184 SERIES
OR EQUIVALENT PRIMARY CONTROL AND A BURNER MOTOR POST-PURGE
L2 OR B2
CONNECT TO
CONNECT TO
L1 OR B1
TRANS
IGNITION
MOTOR MOTOR
VENTER
SERIES OR EQUIVALENT
HONEYWELL R8184
BLACK
JUMPER
CALL
LEGEND:
115 VAC
24V DRY 115V
J2
J1
XL
IMPORTANT:
T
T
F
F
B
ORANGE
WHITE
O
W
OIL VALVE
THERMOSTAT
MM
T
R
N
BURNER
XN
U
N
IVER
SAL
C
O
N
T
R
O
L
AS APPLIANCE INTERLOCK VOLTAGE.
RED JUMPER POSITION MUST BE THE SAME
FIGURE 8050039 3-29-11
FACTORY
WIRED TO
L AND N
ON DCOP1
1. Separate the burner motor wire and ignition transformer from the Orange wire of R8184.
2. Connect the Orange of R8184 to #1 on UC1 terminal block.
3. Connect #2 on UC1 terminal block to White on R8184 and L2 or B2.
4. Connect the HOT wire of oil solenoid valve to #4 on UC1 terminal block and neutral wire to White or N.
5. Connect burner motor and ignition transformer HOT wires to M terminal on UC1 and neutrals to White or N.
6. Make sure RED voltage jumper on UC1 is on 115V.
UC1 UNIVERSAL CONTROL CONNECTED TO A HONEYWELL
R8184 SERIES OR EQUIVALENT PRIMARY CONTROL
24V DRY 115V
J2
XL
J1
AS APPLIANCE INTERLOCK VOLTAGE.
IMPORTANT:
RED JUMPER POSITION MUST BE THE SAME
XN
UNI
VERSAL CO
NT
RO
LLER
BLACK WHITE
BURNER MOTOR
IGNITION TRANS
OR EQUIVALENT
R8184 SERIES
HONEYWELL
BLACK
ORANGE
WHITE
R
FIGURE 8050038 3-29-11
FACTORY
WIRED TO
ON DCOP1
L AND N
WHITE
L2 OR B2
CONNECT TO
CONNECT TO
L1 OR B1
JUMPER
CALL
LEGEND:
115 VAC
1. Separate the Black burner motor wire from the Orange wire of R8184 Primary Control.
NOTE: Do not separate the ignition transformer wire from the Orange.
2. Connect Orange wire of R8184 to #1 on UC1 terminal block.
3. Connect #2 on UC1 terminal block to White on R8184 and L2 or B2.
4. Connect Black of burner motor to #4 on UC1 terminal block.
5. Make sure RED voltage jumper on UC1 is on 115V.