Vinten Radamec Fusion FPR-210 - Manual (Page 30)

Fusion FPR-210 + pedestal
28
1. Switch OFF power to the pedestal [34] and disconnect the power lead [32].
2. Unscrew the four fixing screws [9.1] and lift off the panel [9] to expose the internal
mechanisms.
Fuse replacement
To replace the power box fuse (see Fig. 3), proceed as follows:
1. Ensure that the power supply has been disconnected and isolated from the
pedestal.
2. Rotate the fuse holder [33] counter-clockwise and remove from the power box [15].
3. Remove the defective fuse from the fuse holder [33] and replace with a serviceable
fuse. Refer to Electrical data on page 30 for correct fuse rating.
4. Install the fuse holder [35] into its housing on the power box [15], push and rotate
clock-wise to secure.
Fig. 16 Accessing Wheels and Datum Reference Sensors
WARNING! Risk of electric shock. Always disconnect and isolate the product
from the power supply before replacing the fuse.
[9] [9.1]
[9.2]