Warnings and cautions – Welch Allyn KleenSpec Vaginal Specula Illumination System - User Manual User Manual

Page 6

Advertising
background image

2

Warnings and Cautions

WARNING: To avoid eye injury, do not look into the beam.

WARNING: Lamp is harmful to skin if touched. Allow lamp to cool for 5
minutes before replacing. Lamp generates heat and should remain off until
just prior to and immediately after use. Do not place illuminator onto a
flammable surface if lamp is illuminated.

WARNING: Disconnect transformer from outlet prior to any maintenance.

WARNING: This product is for use with the Welch Allyn KleenSpec Single-
Use Vaginal Specula only. Do not use the illuminator for any other use. Lamp
is hot and can cause a burn if used outside of the vaginal specula.

WARNING: KleenSpec Vaginal Specula Illumination System is not suitable for
use in the presence of a flammable anesthetic mixture with air or oxygen or
nitrous oxide. An explosion may result.

CAUTION: Illumination is intense.

CAUTION: Use only the cleaning methods and disinfection solutions/methods
described in this manual. Clean the device prior to disinfection.

CAUTION: The Illuminator (REF 78800) is a biohazard after use. Follow good
hospital practices and the instructions for cleaning and disinfection of the
illuminator within this manual prior to the next usage.

CAUTION: Ensure lamp is installed and fully seated in illuminator throughout
cleaning and disinfection process. The illuminator assembly is immersible
(IPX7) provided the lamp is properly installed.

CAUTION: This device complies with current required standards for
electromagnetic interference, and should not present problems to other
equipment or be affected by other devices. As a precaution, avoid using this
device in close proximity to other equipment.

U.S. Federal Law restricts this device to sale by or on the order of a physician.

To remove all power from the Vaginal Illumination System, unplug the external
power supply from the wall outlet.

Illuminator is capable of temporary immersion to a depth of 0.15 to 1 meter,
at ambient pressure, at room and fluid temperatures of 22° C to 43° C.

There are no user-serviceable parts inside the device except the lamp.
Contact the Authorized Service Center listed on

page 13

.

Advertising