Welch Allyn Connectivity Server - Programmers guide - Manual (Page 58)

54 Inbound ADT HL7 messages Welch Allyn Connectivity Server
Reconfiguration of ADT services
If your WACS system receives inbound ADT messages from your CIS, and you need to
reconfigure certain ADT service settings, such as the CIS server IP address or the CIS
server port number, please contact Welch Allyn Technical Services (see
“Contact
information” on page 57).
A Technical Service representative can help you access ADT settings in the WACS
program’s HL7 - General Settings page (shown below), which is beneath the WACS HL7
Manager tab. ADT settings in this page are only visible to Welch Allyn personnel.
You can access the WACS program via certain internet browsers on any computer in your
facility’s intranet. For instructions on accessing the WACS HL7 Manager pages, see the
Welch Allyn Connectivity Server (WACS) Directions for Use.
Note If Welch Allyn personnel assist you in accessing certain ADT settings, do not
change ADT settings beyond those with which you are assisted. Changing other
ADT settings can render the WACS system inoperable.
A. CIS server IP address used for inbound ADT messages to WACS
B. CIS server port used for inbound ADT messages to WACS
C. WACS enabled listening for CIS ADT data
A.
B.
C.