Welch Allyn LS200 Procedure Light - User Manual - Manual (Page 14)

8 Chapter 2 Mounting and Operating Instructions Welch Allyn LS200 Procedure Light
5. Place wall plate
on wall and drive
top 1.5" (3.8cm)
wood screw
halfway into
wood stud.
6. Align wall plate
using a level and
secure at bottom
with 1.5" (3.8cm)
wood screw.
7. Tighten top wood
screw.
8. Prepare for transformer mounting by following “Mounting The
Transformer” on page 11 instructions through step 4.
9. Carefully remove LS200 arm/luminaire assembly from box.
Complete transformer mounting according to steps 5 and 6 of
instructions on
page 11 .
10. Place arm/luminaire assembly on
extension arm by sliding universal
connector (B) onto extension arm
(G) and aligning screw holes.
11. Insert 0.5" (13mm) flathead
screw (b) into hole on side of
universal connector and tighten.
Move arm up and down to check
that mounting is secure.
12. Push cord into clips in underside
of extension arm.