Welch Allyn LS200 Procedure Light - User Manual User Manual
Page 16
Advertising
10
Chapter 2 Mounting and Operating Instructions
Welch Allyn LS200 Procedure Light
7. Place wall plate on wall and drive 1.25" (3.2cm) masonry
screw halfway into the wall.
8. Align wall plate using a level and secure by tightening screw.
9. Punch the next three holes with wall plate in place.
10. Drill remaining holes.
11. Fasten wall plate with three remaining screws.
12. Prepare for transformer mounting by following “Mounting The
Transformer” on page 11 instructions through step 4.
13. Carefully remove LS200 arm/luminaire assembly from box.
Complete transformer mounting by following steps 5 & 6 of
instructions on
Advertising