Welch Allyn LS200 Procedure Light - User Manual - Manual (Page 26)

20 Chapter 3 Maintenance Welch Allyn LS200 Procedure Light
4. Locate release lever on lamp holder and push downward (see
D).
5. Grasp expired lamp by its base with two fingers and slide out
of lamp holder (see E).
6. Return release lever to upward position (see F).
7. Remove Welch Allyn Replacement Lamp #06400 from its
package.
8. Grasp replacement lamp between your two forefingers (see
G).
Note Try not to touch the inside of reflector—dirt or oil can
cause reduced light output. Clean according to
instructions on
page 18 , if necessary.