Welch Allyn Connex Integrated Wall System Start Up Guide - Installation Guide - Manual (Page 15)

Startup guide Setup 11
Mount the accessory bin
1. Mount the accessory bin on the accessory bin bracket, then loosely wrap the excess
power cord around the accessory bin bracket.
2. If your wall system is configured for SpO2, attach the SpO2 spool to the accessory
bin by sliding the spool onto the retention clip.
3. Properly orient and insert the SpO2 sensor cable into the patient cable connector.
(You just connected the opposite end of the sensor cable to the wall system.) Ensure
the sensor cable is inserted completely, then close the protective cover. (See the
sensor manufacturer's directions for use.)