Welch Allyn Connex Integrated Wall System Start Up Guide - Installation Guide - Manual (Page 9)

Startup guide Setup 5
Mounting hardware inventory
Use these items to mount the wall system.
Tools list
Use these tools to mount the wall system.
• #2 Phillips screwdriver
• level
• tape measure
• stud finder
• drill
• 1/8-inch (3.17 mm) diameter drill bit
Mounting location
Before mounting the wall system, consider the following recommendations to determine
the best mounting location:
• Mount the wall system to studs.
• Mount the wall system within reach of the AC power outlet. The power cord is 8 ft.
(2.44 m) long.
• Avoid brightly lit areas.
• Blood pressure tubing is 8 ft. (2.44 m) long.
• Position the wall system so that all instruments are accessible and in a location that
allows for ergonomic examinations.
• Mounting rail bracket
• Accessory bin bracket
• Screws
1. Connex Integrated Wall System
2. Examination table
Sample room layout