B&C Technologies DP-250 Industrial - Manual (Page 15)

INSTALLATION PROCEDURES
3-1
SECTION 3
INSTALLATION PROCEDURES
Installation should be performed by competent technicians in accordance with local and
state codes. In the absence of these codes, installation must conform to applicable AMERICAN
NATIONAL STANDARDS: ANSI Z223.1 -LA TEST EDITION (NA TIONAL FUEL CODE) or
ANSI/NFPA No.70 LATEST EDITION (NATIONAL ELECTRIC CODE or in CANADA, the
installation must conform to applicable CANADIAN STANDARDS: CAN/CGA-B149.1-M91
(Natural Gas) or CAN/CGA-BI49.2-M91 (L.P. Gas) or LATEST EDITION (for GENERAL INST
ALLATION and GAS PLUMBING) or CANADIAN ELECTRICAL CODES PARTS 1 & 2 CSA
C22.1-1990 or LATEST EDITION (for ELECTRICAL CONNECTIONS).
Before installing the dryer, be sure the location conforms to local codes and ordinances. in
absence of such codes or ordinances location must conform with the National Fuel Gas Code
ANSI Z223.1-LA TEST EDITION, or in CANADA, the Canadian Installation Codes CAN/CGA-
B149.1-M91 (Natural Gas) or CAN/CGA-B149.2-M91 (L.P. Gas) or LATEST EDITION.
1. The dryer must be installed on a sound level floor capable of supporting its weight. It is
recommended that carpeting be removed from the floor area that the dryer is to rest on.
2. The dryer must not be installed or stored in an area where it will be exposed to water and/ or
weather.
3. This dryer is for use in noncombustible locations.
4. Provisions for adequate air supply must be provided as noted in this manual (refer to Fresh Air
Supply in Section D).
5. Clearance provisions must be made from combustible construction as noted in this manual (refer
to Dryer Enclosure Requirements in Section C).
6. Provisions must be made for adequate clearances for servicing and for operation as noted in this
manual (refer to Dryer Enclosure Requirements in Section C).
7. Dryer must be exhausted to the outdoors (refer to Exhaust Requirements in Section E).
8. Dryer must be located in an area where correct exhaust venting can be achieved as noted in this
manual (refer to Exhaust Requirements in Section E)
IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be
necessary.
A. LOCATION REQUIRMENTS