MK Diamond MK-100 - Manual (Page 15)

15
MK-100 TILE SAW CONTENT
Name
address
City
state zip Code
phoNe Fax
e-mail
produCt model
part NumBer
maChiNe serial#
MK DiaMonD Warranty CarD
q tile distriButor q home CeNter q equipmeNt supply house
q tool supply q Bldg material supply q reNtal equipmeNt house are you a do-it-yourselFer q or CoNtraCtor q I F so, what type? tile q masoNry q other
what Criteria was importaNt iN ChoosiNg this saw? (rate From 1 to 5, 5 BeiNg the most importaNt)
power preCisioN portaBility availaBility other
If within one (1) Year from the date of purchase, this MK Diamond saw fails due to defect in material or workmanship, MK will repair it, free of charge when the unit is re- turned to the dealer where it was purchased. This warranty DOES NOT cover normal wear or damage resulting from operator abuse. In no event shall MK Diamond Products, Inc. be liable for consequential damages arising out of the failure of any product if operated improperly. MK Diamond Products may act as a warranty station for motor/en- gine repairs based on an individual agreement with the manufacturer. This warranty is in lieu of all other warranties express or implied. ©2010 All Rights reserved. MK Diamond Products, Inc. • P/N 155037 MK Warranty Card (02/10)
mK diamoNd warraNty 1315 Storm Parkway, Torrance, CA 90509 USA | www.mkdiamond.com | 1.800.421.5830 | 1.310.539.5158
where did you purChase this saw From? Name
CommeNts or suggestioNs: priCe
date purChased
10.2014
MK-100 TILE SAW OWNER'S MANUAL
PARTS LIST & OPERATING INSTRUCTIONS
www.mkdiamond.com
Caution: Read all safety and operating instructions before using this equipment. This parts list MUST accompany the equipment at all times.
Revision 104
Manual Part# 158192
UNPACKING
Use proper lifting techniques when lifting the MK-100.
If not done, remove the MK-100, Cutting Head and accessory box from the carton.
CONTENTS
MK-100 Frame
and Water Basin
MK-100
Cutting Head
Adjustable
Cutting Guide
Electric Water
Pump
Cooling
Transfer Tube
Blade Nut
Wrench
Drain Plug Splash Guard Flow
Adjusting Clamp
Pump
Manual
Warranty
Card
Owner's
Manual
Diamond Blade
In your container, you will find one (1) MK-100 frame and water basin, one (1) MK-100 cutting head,
one (1) 10-inch wet cutting continuous rim diamond blade, one (1) adjustable cutting guide, one
(1) electric water pump, one (1) splash guard, one (1) cooling transfer tube, one (1) flow adjusting
clamp, one (1) blade wrench, one (1) drain plug, one (1) owner's manual, one (1) pump manual and
one (1) warranty card.
CAUTION
Your MK-100 has been shipped from the factory thoroughly inspected. Only minimal assembly is
required.