MK Diamond MK-100 - Manual (Page 26)

26
Off-angle Cutting
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
CAUTION
(A)
Place the 90° Protractor on
the Ruler/Stop and tighten the
retaining thumbscrew.
(B)
Set the desired angle and
tighten the thumbscrew.
(C)
Position the tile against the 90°
Protractor and the Ruler/Stop.
Turn the motor ON.
(D)
Verify proper cooling flow on both
sides of the blade (See Mainte-
nance Section to increase/de-
crease flow).
(E)
Perform the cut. Turn the motor
OFF when work is complete.
MK-100 OPERATION
To cut angles other than 45° angles or Miter, a 90° Protractor (MK Diamond Part
No. 134569-MK) should be used.
NOTE: