Nextteq Standard Airtec Regulator Kit - Manual (Page 8)

PACKING LIST TABLE OF CONTENTS
8 NEXTTEQ LLC (Rev. 2) 4/09
The system should always be stored in a clean dry place when not in use.
Some bottled breathing air is prepared by blending liquid nitrogen and liquid oxygen at
79% and 21% respectively. Oxygen content should be monitored when this type of
breathing air is used.
DO NOT attempt to remove the Airtec regulator from the breathing air source while the
regulator is under pressure.
Take precautions against water entry into the regulator. Use line pressure to blow out the
connector prior to regulator hookup when sampling compressed air.
Be sure that the weight of the Airtec System is properly supported during hookup to
compressed air lines.
Be sure that any adapters prepared for use of the Airtec System on compressed air lines
are capable of handling line pressure.
NEVER place the Airtec regulator or flow meter in a vise.
Disclaimer of Warranties
Nextteq LLC assumes no responsibility whatsoever, to any party whosoever, for any
property damage, personal injury, or death received by or resulting from, in whole,
or in part, the improper use, installation, or storage of this product by the user,
person, firm, entity, corporation or party not adhering to the instructions and
warnings or not adhering to all federal, state, and local environmental and
occupational health and safety laws and regulations.
The seller shall not be liable for direct, indirect, consequential, incidental or other
damages resulting from the sale and use of any goods and seller’s liability hereunder
shall be limited to repair or replacement of any goods found defective. This
warranty is in lieu of all other warranties, expressed or implied, including but not
limited to the implied warranties of merchantability and fitness for a particular
purpose, which is expressly disclaimed.
WARNINGS