Pilz PSENvip RL D P - Manual (Page 107)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-23
7.5 Setting the parameters for bending angle measurement
7 Commissioning
7.5 Setting the parameters for bending angle measurement 7500 Setting the parameters for bending angle measurement 7- Inbetriebnahme_Biegewinkelmessung_parametrieren
Prerequisite: The PSENvip must be in NORMAL OPERATION status.
To set the parameters for bending angle measurement, follow the in-
structions below:
 Press the <MODE> key.
 Using the keys , select the MEASUREMENT option.
 Press the <ENTER> key.
The menu for setting the parameters for bending angle measurement will
appear.
Fig. 7-20: Setting the parameters for bending angle measurement
A maximum of 5 angles can be monitored to check that they stay within
a tolerance. The accuracy of the measurement can be set.
 Select ANGLE 1 to ANGLE 5 or ACCURACY using the keys
 Press the <ENTER> key.
Change the parameter
 Select the parameter using the keys
 Press the <ENTER> key.
The arrow will be shown in bold. The parameters can now be
changed.
 Press the keys to change the parameters.
 Press the <ENTER> key to accept the values.
 You can exit parameter setting at any time without confirming the en-
try by pressing <ESC>. In this case, the previous values will be re-
tained.
SYSTEM OK OSSD OFF
MENU
MEASUREMENT
ANGLE 1
ANGLE 2
ANGLE 3
ANGLE 4
ANGLE 5
ACCURACY