Satellite Maxim 3000 - Manual (Page 5)

Finish installing the right/left panels.
Push panel firmly against the
base with foot and install (1)
screw PN 13860 vertically into
the dimple (for turbo base or
hole in panel to cored hole in
Roto-base) in the rear pocket. Install (1) lag screw PN
13860 horizontally into the
dimple below the vertical
corner groove. Install (1) lag screw PN
13860 horizontally in the
middle of panel 6-1/2” to rear
of pocket using the dimples
for location. Install the last (2) lag screws
PN 13860 horizontally into
the bottom panel using the
dimples closest to the rear of
the panel.
PN 17674/REV H page 5
Install vent pipe Assemble roof.
Install the vent pipe by
pushing down on the vent pipe
until it seats in the tank. Position the roof over the
panels and vent pipe. Pull the roof down over the
vent pipe from the outside. Hold the Roof flush to Panel
while fastening together. Install
(2) ¾” screws horizontally in the
front right side of the roof .
Finish roof. Install the coat hook .
Screw (2) ¾” screws
horizontally in the rear of the
roof (as shown). Install (3) 1-1/2” long screws
with 5/16” rubber clad washers
[(2) in the rear corners and (1)
in the front right corner.] Drill a hole in the vent pipe
using the dimple for location. Using a silver colored
expanding rivet, attach the coat
hook to the vent pipe.