Satellite Maxim 3000 - Manual (Page 7)

Start door assembly.
Drill the (2) dimples near the
latch using a #10 (0.194”) drill
bit. (if not already drilled) Rivet the door handle to the
door using (2) long black
expanding rivets. Insert the short grey bushing
into the pivot pocket in the
base. Install Gray Bushing into roof
pivot hole.
Door assembly.
Place the long bushing (with
the flange down) over the tube
at the top of the door. Place the spring over the long
bushing. Note the position of
the loop on the spring. Bend the upper leg of the
spring behind the door and
slide the spring downwards.
CAUTION: the spring may slip
and hit your hand. Installed spring viewed from
the inside of the door.
Finish the door assembly.
Install the black washer on the
bottom of the door tube. Drill 11/32” (0.344) hole at
dimple through panel for
spring arm u-nut. Install u-nut onto bottom of
spring arm loop. (Note: when
spring arm is back under roof
the barrel of the u-nut to be
toward rear of unit.
PN 17674/REV H page 7