Satellite Maxim 3000 - Manual (Page 8)

Install the Door.
Insert the door tube into the
short bushing installed in the
base. Bottom spring will sit on
base. (Make sure black washer
is on door tube). Insert bottom spring arm
between facing and base. Push
down with your foot into space
between panel and the base. Lift the roof up, pull the door
into position and pull the roof
down over the door tube. Push spring arm up until it
contacts inside of roof in
groove, where panel sits. Pull
down on roof to trap spring
arm. (Be very careful the spring
arm doesn’t slip and hit your
hand.)
Finish roof and door installation.
Install 1-1/2” screw with 5/16”
rubber clad washer in the front
top left corner. Pull down on the roof as shown
and install two ¾” screws. Install 5/16-18 x 1-1/2” Torx
head bolt from outside through
panel and into u-nut. You will
need a person inside, with a
Pliers, to hold u-nut. Tighten bolt only until spring
arm is approximately 1/8” from
panel surface.
Install the tank.
To properly seat the tank, have
someone stand in it as shown.
This person should signal when
the screws have tightened the
panel to the tank. Install two lag screws in the
rear panel. Use the recesses
and dimples for the locations.
Note: Do back screws first! Install a lag screw in the left
panel. Use the recess and
dimples for the locations. If installing the Maxim 3000
Handwash, do so before
installing the right side lag
screw.
PN 17674/REV H page 8