Satellite Maxim 3000 - Manual (Page 6)

Install the urinal.
Drill dimple with #10 drill bit Place the drain tube of the
urinal into the hole in the
tank Insert rivet into the urinal and
panel to hold its position
while drilling the other hole. While one person holds the urinal in
place. insert rivets through the panel
from the outside and into the urinal.
Place 3/16” backup washers on the
inside and set rivets.
Install the hasp. Install the paper guard.
Using a #10 (0.194”) drill bit,
drill the two dimples in the
right panel. Rivet the hasp to the panel
using two silver expanding
rivets. Note: position the slot
in the hasp as shown. The paper guard can be installed
in two locations: the Right panel
in Straight drop units or Left
panel for units with Handwash
Stations or Swish Tanks. Note: When installing with
Swish Tank, position paperguard
bottom 2" above the top two
dimples, mark and drill using
holes in paperguard and rivet.
Finish paperguard installation.
Drill the four dimples shown
for the paperguard using a #10
(0.194”) drill bit. (use drill stop
to prevent drilling through
outside wall.) Insert 3/16" T Rivets through
the top most hole in the
paperguard. Position the
paperguard and rivet. Rivet the other top hole in the
paperguard. Rivet the two
lower holes in the paperguard
to the panel using two more
3/16" T rivet. Insert the spindle into the
paperguard. Note: position the
hook as shown.
PN 17674/REV H page 6